newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles with a CAN-BUS system.
The resistor CBW1 provides a required electrical load for your vehicle, which, if the dip switches are set correctly, means that there is no error message in the cockpit for accessory indicators.
There is also reliability. This means:
If the accessory turn signals fail due to an electronic defect, an error message is immediately displayed in the cockpit.
Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.
If 2 pairs of indicators (VL, VR, HL, HR) are exchanged, 2 x CBW1 are required.
What are the requirements for using the CBW1 on the vehicle:
Either:
LED indicators were installed on the vehicle in their original condition.
Or:
The vehicle has a CAN-BUS system.
If none of the requirements are met, the CBW1 cannot be installed (!), We recommend the following resistances for the vehicle:
For indicators with 21 watts
6.8 ohms item number 207-025
or
10 Ohm item number 207-028
For turn signals with 10 watts
27 ohm item number 207-020
The following resistance values can be set:
150 ohms
170 ohms
200 ohms
240 ohms
300 ohms
400 ohms
600 ohms
1200 ohms
Dimensions:
Height = 11 mm
Width = 31 mm (without tabs)
Width = 46 mm (with tabs)
Length = 40 mm
Cable length = 200 mm with pins
Connections:
Yellow = input channel 1 (+)
Orange = output channel 1 (+)
Blue = input channel 2 (+)
Red = output channel 2 (+)
Gray = input mass (-)
Black = output ground (-)
Scope of delivery: 1 piece
Hints:
Up to 2 channels can be operated.
The connection is explained in detail in the operating instructions!